Chapter 2: Hardware setup
Chapter 2: Hardware setup
Chapter 2: Hardware setup
Chapter 2: Hardware setup
Chapter 2: Hardware setup
2-2
2-2
2-2
2-2
2-2
2.1
Chassis cover
The chassis features a “screwless design” that allows convenient assembly
and disassembly. You can simply push or slide mechanical bolts and locks to
remove the cover.
2.1.1
2.1.1
2.1.1
2.1.1
2.1.1
Removing the side cover
Removing the side cover
Removing the side cover
Removing the side cover
Removing the side cover
1.
Remove the two screws that
secure the cover to the chassis.
2.
Slide the side cover for about
half an inch toward the rear until
it is disengaged from the
chassis.
3.
Carefully lift the cover and set it
aside.
Viewing the internal structure
Viewing the internal structure
Viewing the internal structure
Viewing the internal structure
Viewing the internal structure
Without the side cover, the internal structure and installed components of
the barebone server vary depending on the model you purchased. Refer to
section “1.5 Internal features” for the different model configurations.
Perform the procedures in the succeeding sections to install the CPU,
system memory, disk drives, and expansion cards; replace fans and power
supply; and connect the system cables.
1
1
1
1
1
1
1
1
1
1
2
2
2
2
2