Page 10

ASUS ASMM User’s Manual

I. ASUS ASMM

System Control

Reset Button: Hard reset enable/disable

Keylock: keyboard lock/unlock

ASR: Enable, disable, and test

ASR period: ASR period selection through mini-jumper (30/120/240/330 seconds)

Chassis Intrusion: As this status will be backup through battery, one can clear the

memorization of intrusion circuit.

System Notification

The system can be notified when the voltage/temperature/fan speed exceeds the

predefined thresholds. The notification mechanism can be as simple as polling or

through SMI#/IRQ service routine, depending on the programming of LM78. Five

ISA IRQs can be selected (IRQs 3, 4, 5, 6, 7) through hardware jumper.

I.ASUS

ASMM

System/Cabling

ASMM Color-Coded Cabling

These connections are classified into 3 categories: chassis intrusion, fan monitor,

and server monitor.

Chassis intrusion: Chassis intrusion permits the activation of a user-installed alarm.

One 3-wire cable supports the external customized chassis intrusion alarm. The pin

definitions are: RED (battery power), YELLOW (intrusion signal), and BLACK

(ground). The external intrusion signal should be open-drained.

Fan monitor: The fan monitor provides power for up to 3 fans while monitoring

the connected fans’ rotation through the specially designed tachometer. Three 3-

wire cables are used to extend the length of each fan connection. The pin definitions

are: YELLOW (tachometer signal), RED (+12V), and BLACK (ground).

Server monitor:

The server monitor contains many signals that can be monitored

and controlled through the software. The server monitor signals are: CPU voltage

ID for Pentium II processor (N.A. in P/I-P65UP8), key lock and reset, CPU1 and

CPU2 Vcore (N.A. in P/I-P65UP8), +3.3V, I2C bus (N.A. in P/I-P65UP8), and CPU1

and CPU2 thermister (N.A. in ASMM), EXTSMI#. One 20-wire ribbon cable is

used. The red stipe indicates pin 1.

NOTE: If you want to test the security mode, the KEYLOCK and RESET connec-

tions must be correct. If the position of the reset signal is wrong, the reset inhibit

function may not work.