Chapter 2: Hardware setup
2-54
To install a 600 W single power supply module:
1. Firmly hold the power supply
module and insert it into the
power supply cage.
2. Push the power supply all the
way in until its outer end aligns
with the rear panel.
Be careful with the power supply cables when inserting the power
supply module into the cage. Due to space constraints, the cables may
get entangled with the installed components or other cables, causing
the cables to break!
3. Place the metal plate flat on the
outer end of the power supply
module, flushed to the top of the
chassis, while matching the four
hooks with their corresponding
holes on the rear panel.
Hook matched to a hole
4. Hold the metal plate bar and
push it upward to lock the hooks
to their holes. At the same time,
you may also push the top of the
metal plate to fit it completely.
5. Secure the metal plate with the
thumb screw.